Upload Design (Metallic Foil Business Cards)

1. Supply fonts larger than 8pt
2. Use sans serif fonts
3. Avoid having artwork underneath the foil areas (i.e. using a mask instead)
4. Avoid areas of heavy foil coverage with small/fine (non-foil) text or linework knocked out, as there is a tendency for these to fill in.
5. CAUTION: We do not recommend extending the foil design to the trimmed edge of the card, as there would be a high possibility of the foil peeling off along the trimmed edges. There should be at least a 5mm foil-free area around the edges. If you supply foil files with full bleed, please note our automation will automatically apply a 5 mm gap (from the trim edge) on your foil files to prevent the risks of the trimmed edges lifting/peeling. The non-foiled gap area may be visible along the edges as a result. It is best to avoid full bleed on your foil files for the above reasons.

Step 1

Ensure the file matches the product's required dimensions. Ensure that the artwork is created in CMYK 300 dpi with 1/16-inch bleeds on all sides.

Make sure that all images are embedded, and that all the text is outlined.

Step 2

Make sure that all images are embedded, and that all the text is outlined.

Step 3

Export all files into PDF format with bleeds.